POLYFLOW - The calculation is aborted with the message "Number of coefficients exceeded !".

When running a large simulation case, or a case involving a lot of constraints (boundary conditions, etc.), POLYFLOW may be aborted before the first iteration, with the error message "Number of coefficients exceeded !".
In most cases, this can be circumvented by entering (or modifying) an option in the .p3rc file. This can be fixed as follows. In POLYMAN, Select the simulation and click on Tools / Options / Polyflow. In the box "Modify .p3rc configuration file", add


The factor '30' is indicative, and can be increased if the message 'Number of coefficients exceeded!' still appears. Then, run the calculation again.

Show Form
No comments yet. Be the first to add a comment!