Why is my cyclic symmetry analysis giving thousands of warning messages
of the following type?
Term= 3 on CE number= 17 is not active on any element
This CE is ignored.
Your edge nodes are attached to elements with only translation dof, but you have a beam in the model with 6 dof. This causes the program to write cyclic symmetry constraint equations for non-existent rotational dof. To correct this problem use the CYCOPT command to specify the dof to be used as shown below. CYCOPT,DOF,1,UX,UY,UZ ! For pair 1 CYCOPT,DOF,2,UX,UY,UZ ! For pair 2 |
||
|