POLYFLOW - I get the message "Number of constraints exceeded !".

When running a large simulation case, or a case that involves a lot of constraints (boundary conditions), POLYFLOW may be aborted before the first iteration, with the error message "Number of constraints exceeded !".
In most cases, this can be circumvented by entering (or modifying) an option in the .p3rc file. This can be fixed as follows. In POLYMAN, Select the simulation and click on Tools / Options / Polyflow. In the box "Modify .p3rc configuration file", add

MCONTR 30

The factor '30' is indicative, and can be increased if the 'Number of constraints exceeded!' message still appears. Then, run the calculation again.





Show Form
No comments yet. Be the first to add a comment!