Q. I am trying to run a FLOTRAN case with an input file which describes the properties of Air with the names as listed in the ANSYS commands manual. However, it doesn't work. Why?
A. An error was introduced into the documentation at ANSYS 8.0. The following list provides what the property names should be.
Change AIRSI to AIR-SI
Change AIRSI_B to AIR-SI_B
Change AIRCM to AIR-CM
Change AIRCM_B to AIR-CM_B
Change AIRMM to AIR-MM
Change AIRMM_B to AIR-MM_B
Change AIRFT to AIR-FT
Change AIRFT_B to AIR-FT_B
Change AIRIN to AIR-IN
Change AIRIN_B to AIR-IN_B
Also, in two places, fl-slug-sec should be changed to ft-slug-sec
Q. I am trying to run a FLOTRAN case with an input file which describes the properties of Air with the names as listed in the ANSYS commands manual. However, it doesn't work. Why? A. An error was introduced into the documentation at ANSYS 8.0. The following list provides what the property names should be. Change AIRSI to AIR-SI Change AIRSI_B to AIR-SI_B Change AIRCM to AIR-CM Change AIRCM_B to AIR-CM_B Change AIRMM to AIR-MM Change AIRMM_B to AIR-MM_B Change AIRFT to AIR-FT Change AIRFT_B to AIR-FT_B Change AIRIN to AIR-IN Change AIRIN_B to AIR-IN_B Also, in two places, fl-slug-sec should be changed to ft-slug-sec |
||
|