Q. A customer is experiencing problems with the piping module. When, say, an elbow is inserted, instead of picking up the correct pipe properties from the two elements between which the elbow is being made, it defaults to the properties of the last defined section. Thus bend radius, if set to LR or SR, is wrong and other real constant data calculated by the piping module is thrown into question. What is the cause.
A. This is a code defect (#26606). It has been corrected for 11.0 release.
|
Q. A customer is experiencing problems with the piping module. When, say, an elbow is inserted, instead of picking up the correct pipe properties from the two elements between which the elbow is being made, it defaults to the properties of the last defined section. Thus bend radius, if set to LR or SR, is wrong and other real constant data calculated by the piping module is thrown into question. What is the cause. A. This is a code defect (#26606). It has been corrected for 11.0 release. |
||
|