I did the following steps in ANSYS Workbench Environment (AWE), but no components are shown in ANSYS Classic Environment.
What else must be done?
1. Imported geometry and created a named selection in Workbench.
2. Chose "Open analysis in ANSYS" from the project pane to transfer
the simulation into Classic ANSYS.
3. Once ANSYS opened, chose the Component Manager from "List -->
Component Manager". The named selections should appear here, but don't.
|
In order for ANSYS Workbench Environment to properly create the component definitions for the ANSYS Classic Environment, you need to have the Environment and Solution branches completed. You can do this, for example, by creating a fixed support, a force, and a solution item of equivalent stress. You would then open the model in the ANSYS Environment. |
||
|