Problem finding a Workbench file associated with a DesignModeler and CFX-Mesh file in ANSYS 10.0
|
Here is a workaround if you think that your DesignModeler (*.agdb) and CFX-Mesh file are disassociated from a Workbench database (*.wbdb). If you do this, it's recommended that you take a back-up copy of all of the files beforehand, in case anything goes wrong. - You should still be able to open the designmodeller geometry. If you open this and save it, it should be linked to a workbench database. The main problem is the CFX-Mesh files: - Firstly, copy the existing .cmdb and .cmdat files to another directory somewhere. - Now start a new CFX-Mesh session and save a new (blank) set of .cmdb and .cmdat files. - Exit workbench, saving if prompted. - Replace the new .cmdb and .cmdat files with the old ones you took a copy of. - Re-open the project in Workbench. If you select CFX-Mesh, you should be back to where you started. The same procedure can be used to copy the existing settings from an existing mesh to a new one. Suggestion for general working, if you want to use DesignModeler, then always start up by clicking on a Workbench (*.wbdb)file, rather than from a DesignModeler file (*.agdb). |
||
|