Why does this tapered BEAM188 model give the message below that
integration point is outside of end stations?
*** ERROR *** CP = 4.688 TIME= 12:58:02
Element 1 integration 1 point is located outside of end stations.
Please verify section input -0.983109446. / - please check the ftp site***
Tapered beams have to lie on a line between the sections used to define the taper. I listed tapered section 10 below. Element one`s nodes don't lie between these two points. Admittedly, this requirement makes it difficult to define curved tapered beams. SECTION ID NUMBER: 10 BEAM SECTION TYPE: TAPERED BEAM BEAM SECTION NAME IS: topcon1 Section 1 at 6.3000 -65.000 9.0000 Section 2 at 10.000 -65.000 9.0000 |
||
|