Why do I receive the following error message when installing ANSYS Pressure Equipment Module 11.02?
Error 1315.A network error occurred while attempting to read from the file
C:Docume~1jvwLocals~1Temp_is48BANSYS Pressure Equipment Module 11.01.msi.
OK
If you have installed the ANSYS Pressure Equipment Module 11.01 you will need to uninstall it. Two ways to do that: 1)Run the setup file that has been used to install PEM 11.01 and choose uninstall. 2)Go to the Windows Control Panel >Add/Remove program and click on ANSYS Pressure Equipment Module 11.01. This will allow the installation to complete successfully. |
||
|