port definition Designer SoD

coax ports need to have a radial extend to be passed thru hierachy by cross proble layout, in schemtaic window RMB, add interface ports:

select the pin and the "interface port"
- Add a wire/connection. This should be visible in top-down view with Rats layer on, if not already there
- you may check with `Cross probe layout` ` RMB ` add interface ports
- Set the Radial Factor to 0.4 (or whatever works for you). Port geometry can be seen versus Symbols layer, as there's no geometry associated with the pin in PCB context

Show Form
No comments yet. Be the first to add a comment!