Q. A model with PLANE55 and SURF151 elements has been made. On the SURF151, (keyopt8=1), a heat flux is applied. When an SFELIST command is issued after the application of the heat flux, a convection load with a film coefficient value equal to the applied heat flux has been created as well as the heat flux itself. This does not seem right. How should the user understand the meaning of this convection load?

A. This is a code defect (report #33543) which has been corrected for the ANSYS 10.0 release.


Q. A model with PLANE55 and SURF151 elements has been made. On the SURF151, (keyopt8=1), a heat flux is applied. When an SFELIST command is issued after the application of the heat flux, a convection load with a film coefficient value equal to the applied heat flux has been created as well as the heat flux itself. This does not seem right. How should the user understand the meaning of this convection load?

A. This is a code defect (report #33543) which has been corrected for the ANSYS 10.0 release.





Show Form
No comments yet. Be the first to add a comment!