I am assuming that this license (advmesh) is only in use for the short time that Design Simulation takes to mesh the model. After the model is meshed, the license is released, correct?

The advmesh license is not released after the mesh. However, it is also enabled by ANSYS Structural and higher licenses at 9.0 and therefore does not require the advmesh license. You can test it by going into Simulation, importing a geometry, inserting a 'Method' in the Mesh branch, and selecting the 'Hex Dominant' method. Then, when the mesh starts, the license is checked out. At WB 9.0 it remains checked out until you close WB. At 10.0 it will be released when all Simulation licensed applets are closed in WB (Simulation, FE Modeler, etc.).

Show Form
No comments yet. Be the first to add a comment!