Q) I am having a memory problem using a GGI interface where two solids are meeting.
I have imported the solids in 1 part directly from a CAD source into CFX-Mesh, but it comes in as seperate parts (bodies)



A) To get the solids to `see' each other without them being in the same part, you will need to specify them as periodic pairs.
i.e. each pair of faces that share the same surface you need to make them a periodic pair. Make sure you have the transformation as 0 0 0
This should give 1-1 interfaces in Pre and therefore the memory problem should disappear.


Q) I am having a memory problem using a GGI interface where two solids are meeting.
I have imported the solids in 1 part directly from a CAD source into CFX-Mesh, but it comes in as seperate parts (bodies)



A) To get the solids to `see` each other without them being in the same part, you will need to specify them as periodic pairs.
i.e. each pair of faces that share the same surface you need to make them a periodic pair. Make sure you have the transformation as 0 0 0
This should give 1-1 interfaces in Pre and therefore the memory problem should disappear.





Show Form
No comments yet. Be the first to add a comment!