Why do I get a message the message below in ANSYS 9.0 when I issue the CYCPHASE command?

*** WARNING *** CP= 20.870 TIME= 13:21:17

Phase angle evaluation (CYCPHASE cmd) is valid only for nodal-diameter
solutions greater than 0 and less than N/2 (N = number of sectors in
the full 360 degrees model). Current nodal-diameter is 7.

I have 15 sectors and I am reading the results for ND = 7. 0 < ND = 7 < 7.5


You didn't issued the SET command which is required for CYCPAHSE. An error
trap has been added in ANSYS 10.0 to alert the user to this.

[Ref: Defect 30956]





Show Form
No comments yet. Be the first to add a comment!