Why is file.tri being written when performing large deflection prestressed PSD in ANSYS 10.0?
This file grows to a remarkable (>40GB) size. Is there any way to prevent this file from being written?


This is an error in the PSOLVE command [Ref: Defect 39479.]
It is fixed in 11.0.

A possible workaround is to run an additional static load step with a single iteration (NEQIT,1) and
NLGEOM,OFF. Then an ordinary prestressed modal could be used without PSOLVE.





Show Form
No comments yet. Be the first to add a comment!