POLYFLOW - I get the message "Number of constraints exceeded !".
When running a large simulation case, or a case that involves a lot of constraints (boundary conditions), POLYFLOW may be aborted before the first iteration, with the error message "Number of constraints exceeded !".
In most cases, this can be circumvented by entering (or modifying) an option in the .p3rc file. This can be fixed as follows. In POLYMAN, Select the simulation and click on Tools / Options / Polyflow. In the box "Modify .p3rc configuration file", add
The factor '30' is indicative, and can be increased if the 'Number of contraints exceeded!' message still appears. Then, run the calculation again.
Further details can be found on the FAQ located at the address
<a target=_blank href="http://www.fluentusers.com/polyflow/FAQ/poly42.htm">http://www.fluentusers.com/polyflow/FAQ/poly42.htm</a>http://www.fluentusers.com/polyflow/FAQ/poly42.htm